Nope there are no passwords, I've got it to the point where I telnet into async 1 port and it opens it up, but nothing comes on the screesn, It just says open. I think there might be a speed mismatch issue, device that is attached to it runs at 2400 and I do no think that you can set access server to run at the speed lower then 9600. So if anyone has any ideas please help. Here is the config: interface Ethernet0 ip address 192.168.190.25 255.255.255.0 no ip route-cache no ip mroute-cache ! interface Serial0 no ip address no ip route-cache no ip mroute-cache shutdown ! interface Serial1 no ip address no ip route-cache no ip mroute-cache shutdown ! interface Async1 no ip address async mode dedicated no peer default ip address ! ip default-gateway 192.168.190.2 no ip classless ip route 0.0.0.0 0.0.0.0 192.168.190.2 ip route 192.168.78.0 255.255.255.0 192.168.190.2 ! line con 0 line 1 8 no exec modem InOut transport preferred telnet transport input all stopbits 1 speed 38400 line 9 16 line aux 0
Tarak Robbana wrote: > Is there a password set on the device your telneting into? Sorry, > have to start with the small stuff. [GroupStudy.com removed an attachment of type text/x-vcard which had a name of khramov.vcf] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=21939&t=21877 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]