What does "show port capabilities" show you Brad?
""Brad Moss"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > I am trying to connect two cat5500s and am unable to get port channel to > come online. I have configured both sides below is the config of the ports. > Any help would be greatly appreciated. These are production switches the > only thing I have to done is reboot them. For some reason they are not > recognizing that they are connect to the same switch on the other end of > either link. I am unaware on any "special" things that must happen for port > channeling both blades support it. > > > Set po channel 8/3-4 mode desirable > Set trunk 8/3 isl on > Set trunk 8/4 isl on > > Set po channel 1/1-2 desirable > Set trunk 1/1 isl on > Set trunk 1/2 isl on > > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ ----- ------- -- > --- > 8/3 connected trunk normal full 100 100BaseFX > MM > > Port Status Channel Admin Ch > Mode Group Id > ----- ---------- -------------------- ----- ----- > 8/3 connected desirable non-silent 157 0 > > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ ----- ------- -- > --- > 8/4 connected trunk normal full 100 100BaseFX > MM > Port Status Channel Admin Ch > Mode Group Id > ----- ---------- -------------------- ----- ----- > 8/4 connected desirable non-silent 157 0 > > SJMDFSW01> (enable) sho po channel > No ports channeling > > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ ----- ------- -- > --- > 1/1 Uplink SJMDFSW01 connected trunk normal full 100 100BaseFX > MM > > Port Status Channel Channel Neighbor Neighbor > mode status device port > ----- ---------- --------- ----------- ------------------------- --------- - > 1/1 connected desirable not channel > > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ ----- ------- -- > --- > 1/2 Uplink SJMDFSW01 connected trunk normal full 100 100BaseFX > MM > > Port Status Channel Channel Neighbor Neighbor > mode status device > port > ----- ---------- --------- ----------- ------------------------- --------- - > 1/2 connected desirable not channel > > SJDCSW02> (enable) sho po channel > No ports channelling > > > Brad Moss, CCNA > Network Administrator > CHRISTUS St. Joseph's Medical Center - South > www.christushealth.org > (903) 737-3160 > [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=23699&t=23692 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
