You can go to the switch prompt to check MLS by using the command . There are other options with this command. ""Thomas"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > I am now very confused. On the 6509, if I put "show mls rp", it said MLSs > was globally disable. When I turned on MLS on both global and interface > mode (include vlans that have NAT), it took just fine. Now I issued "show > mls rp interfaces", VLANs with NAT didn't appear on the list of interfaces > enabled for MLS, though those VLANs took the command without error. > > On Cisco documentation, it says the above set of commands are only for CAT > 5000 platform; and that MLS will be automatically disable on VLANs running > NAT. It also says that MLS is enabled by default on 6509s. Issuing a > command "show mls status" on 6509 MSFC will show the output below. However, > if you do a ? browsing after "show mls", you won't see a subcommand > "status". But if you just type the whole command "show mls status", it > doesn't give any error, but yield the output below: > > MLS global configuration status: > > global mls ip: enabled > global mls ipx: enabled > global mls ip multicast: enabled > current ip flowmask for unicast: destination only > current ipx flowmask for unicast: destination only > > According to this, I assume 6509 has both MSFC and sup. engines enlabled for > MLS, but I am not sure if VLANs with NAT still running MLS... How should I > check it? What about Multicast MLS for NATed VLANs? > > Thomas N. > > > > ""MADMAN"" wrote in message > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > I have never tried so I gave er a go and it took the command just > > fine: > > > > > > C6509> ses 16 > > Trying Router-16... > > Connected to Router-16. > > Escape character is '^]'. > > > > > > User Access Verification > > > > Password: > > MSFC16>en > > Password: > > MSFC16#conf t > > Enter configuration commands, one per line. End with CNTL/Z. > > MSFC16(config)#inter vlan 50 > > MSFC16(config-if)#ip nat inside > > MSFC16(config-if)#^Z > > MSFC16# > > > > Dave > > > > "Thomas N." wrote: > > > > > > Anyone have any problem turning on VLAN interfaces that are running on > NAT > > > protocol? I couldn't turn VLAN on my 6509 that has "ip nat inside" > > > statement. Thanks! > > > > > > Thomas N. > > -- > > David Madland > > Sr. Network Engineer > > CCIE# 2016 > > Qwest Communications Int. Inc. > > [EMAIL PROTECTED] > > 612-664-3367 > > > > "Emotion should reflect reason not guide it"
Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24716&t=24595 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
