We do it all over in our LSS service, (LAN Switching Service). Though we no longer use 4700's, dead product, it works fine and these things were bridging. Only time we had a very strange problem that has never been resolved was a customer connect about 6 sites thru this fully meshed service with a completely flat 5000 node network!! Finally convinced them to put routers on the inside of these 4700 bridges.
If it's only for a lab then certainly go ahead. Dave Circusnuts wrote: > > I found on the CCO where it is not recommended not to run FE and ATM modules > on the same 45 or 4700 router. I have a 4500 and 4500M, both running NP-4Ts, > NP-1FE, and NP-1R & NP-2R modules. Has anyone had experience with running > ATM > and FE on the same router ??? Cisco says it's a big no-go, but it's only > with > home lab scenarios. > > Any advice ??? Fortunately or unfortunately, the OC3 modules are in the mail > as we speak. > > Thanks > Phil -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=26848&t=26788 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]