All, I need a little assistance. Can anyone provide some input on what I am doing wrong.
I am trying to do a simple lab where you have to dial "9" or "8" then you hear a pause and you then are able to dial the other phone hanging off my VIC FXS card. The problem I am having is that everytime I dial 9 or 8 via my analog phone I get a fast busy. When I dial the # programmed on the port, the call goes thru fine. I put in my config the prefix 9, statement and the call still does not work.Can anyone advise what I might be doing wrong. Below is the statement All I am trying to do is call between phones hanging off the same router except dial a prefix before dialing the correct #. It is sort of like being a work and you have to dial a 9 or 8 to reach a outside line. dial-peer voice 1 pots destination-pattern 8516426 port 1/0/0 prefix 9, ! dial-peer voice 2 pots destination-pattern +6775329 port 1/0/1 prefix 8, I have a Cisco 2610 router. IOS is 12.2. Ram 48 flash 16. 2610 with 48 ram 16 meg flash NM 1V 1 FXS Any suggestions ? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=29681&t=29681 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]