It appears that the router is dialing but the calls are failing. Can we see the output of "show isdn stat" as well as "debug isdn events" and/or "debug isdn q921" and "debug isdn q931" ?
John ________________________________________________ Get your own "800" number Voicemail, fax, email, and a lot more http://www.ureach.com/reg/tag ---- On Mon, 31 Dec 2001, McHugh Randy ([EMAIL PROTECTED]) wrote: > This is router 1 > r1#sh run int bri 0 > Building configuration... > > Current configuration : 124 bytes > ! > interface BRI0 > ip address 172.16.2.1 255.255.255.0 > dialer string 2002 > dialer-group 1 > isdn switch-type basic-5ess > end > dialer-list 1 protocol ip permit > r1#sh dialer > > BRI0 - dialer type = ISDN > > Dial String Successes Failures Last DNIS Last status > 2002 0 10 00:10:08 failed > Default > 0 incoming call(s) have been screened. > 0 incoming call(s) rejected for callback. > > BRI0:1 - dialer type = ISDN > Idle timer (120 secs), Fast idle timer (20 secs) > Wait for carrier (30 secs), Re-enable (15 secs) > Dialer state is idle > > BRI0:2 - dialer type = ISDN > Idle timer (120 secs), Fast idle timer (20 secs) > Wait for carrier (30 secs), Re-enable (15 secs) > Dialer state is idle > r1# > 01:30:17: BR0 DDR: cdp, 275 bytes, outgoing uninteresting (no list > matched) > 01:30:17: BR0 DDR: sending broadcast to default destination -- failed, > not > connected > > This is router 2 > r2#sh run int bri 0 > Building configuration... > > Current configuration : 124 bytes > ! > interface BRI0 > ip address 172.16.2.2 255.255.255.0 > dialer string 2001 > dialer-group 1 > isdn switch-type basic-5ess > end > dialer-list 1 protocol ip permit > > r2#sh dialer > > BRI0 - dialer type = ISDN > > Dial String Successes Failures Last DNIS Last status > 2001 0 2 00:16:14 failed > Default > 0 incoming call(s) have been screened. > 0 incoming call(s) rejected for callback. > > BRI0:1 - dialer type = ISDN > Idle timer (120 secs), Fast idle timer (20 secs) > Wait for carrier (30 secs), Re-enable (15 secs) > Dialer state is idle > > BRI0:2 - dialer type = ISDN > Idle timer (120 secs), Fast idle timer (20 secs) > Wait for carrier (30 secs), Re-enable (15 secs) > Dialer state is idle > > > I tried reversing the numbers for the dialer string like 2001 and 2002 > on > each router just in case I had the numbers for the dialer strings > reversed > but that did not help. > Any suggestions appreciated. > Thanks > Randy [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=30594&t=30589 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
