D'Wayne- Under the Interface Config mode, you need to specify the following command:
Router(config-if)#physical-layer ? async Configure asynchronous physical layer on serial interface sync Configure synchronous physical layer on serial interface Router(Config-If)# Physical-Layer Async Good Luck! Mark Odette II -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of D'Wayne Saunders Sent: Wednesday, January 16, 2002 9:42 AM To: [EMAIL PROTECTED] Subject: wic 1T [7:32133] Hi all i have been searching on the cisco site for some information relating to WIC1T. I have just installed one into a 1720 for a modem connection now by cisco (or the information i can find ) the 1720 with this module supports both aysnc and sync's modes. now my question is do i have to do anything special to get it to work in async mode . by the way my ios is 12.0(3)T any help appreciated D'Wayne Saunders, Network Administrator Ph:08 89507742 Fax:08 89521112 Mobile: 0419 823 568 www.lasseters.com.au World's First Government Licensed and Regulated Online Casino... **************************************************************************** *********************************************** This email message (and attachments) may contain information that is confidential to Lasseters Online. If you are not the intended recipient you cannot use, distribute or copy the message or attachments. In such a case, please notify the sender by return email immediately and erase all copies of the message and attachments. Opinions, conclusions and other information in this message and attachments that do not relate to the official business of Lasseters Online are neither given nor endorsed by it. **************************************************************************** *********************************************** Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=32193&t=32133 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]