Do "erase flash" or "delete flash" Then "squeez flash" Also check your config register if it is set to go to ROMMON. Set it to 0x2102 to boot from flash Save config before reload.. It will go to ROMMON if config reg is set or no image is found on flash and it loads boot image. Also make sure that router memory is enough to load image into RAM.
Nadeem ====== "Wilson, Christian" wrote: > Begging for help once again . . . > > I have upgraded the flash in a 3640 from the 8 Mb chip to a 16 Mb chip. I > did this by installing the second, 16 Mb chip into slot 1 of the > motherboard, leaving the original 8 Mb in slot 1, for a total of 24 Mb of > flash memory. I then installed 12.1, which was the reason I needed to > upgrade the flash. 12.1 went on without a hitch, but when the router was > reloaded, it would run for about 30 minutes and then go into rommon mode. > It did this repeatedly, so I removed the 8 Mb chip, installed the 16 Mb chip > into slot 0, and then used xmodem to transfer 12.1 through the console, a > painstaking two hour task. Now the file is on flash, but at reload the file > is unable to decompress, returning these errors: > > Error: Uncompression of the image failed. > invalid compressed data-format violated > > Error: zip decompress failed > > ***System received a software forced crash *** > signal = 0x17, code = 0x7, context = 0x0 > PC = 0x80008094, cause = 0x20, Status Reg = 0x3041f003 > > The crc checks are the same as displayed on the software centers web page. > I have downloaded a new copy of the file and it still did not work. I put > the original 8 Mb chip in slot 0 and removed the 16 Mb chip, reloaded a > fresh 11.3 image, and received the same errors. What have I done?? -- ==================== Ishrat Nadeem Zahid CCNP Cisco Systems,Inc. Chelmsford, MA 01824 Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=35254&t=35184 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
