Do you actually see any ILMI messaging across the DSL link? I would be very surprised to learn that any of the DSL providers are bothering with ILMI on DSL. It is sometime difficult to get them to enable ILMI on their real ATM links....
Chuck ""Mark Odette II"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Matt- Why don't you use the config example from this: > Configuring a Cisco 1700/2600/3600 ADSL WIC With IRB and > NAT Using RFC1483 Bridging > http://www.cisco.com/warp/public/794/wicadsl_rfc_irb_nat_1.html > > This is what I just used to set up an ADSL WIC on a 1720, and it pretty much > took right off. > > bridge irb > ! > ! > interface ATM0 > no ip address > atm ilmi-keepalive > pvc 0/16 ilmi > ! > pvc 0/35 > encapsulation aal5snap > ! > dsl operating-mode auto > no fair-queue > bridge-group 1 > hold-queue 224 in > ! > interface FastEthernet0 > description connected to Private LAN Block > ip address 192.168.10.1 255.255.255.0 > ip directed-broadcast > ip nat inside > no ip mroute-cache > no keepalive > speed auto > full-duplex > ! > interface BVI1 > ip address x.x.x.x 255.255.255.248 > ip nat outside > ! > ip nat inside source list 122 interface BVI1 overload > > ip route 0.0.0.0 0.0.0.0 bvi1 > > > .... and the best part is, you can use that second ethernet interface as a > DMZ! > > Just my .00000010 though. > > -Mark > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of > ipguru1 > Sent: Wednesday, April 17, 2002 10:43 AM > To: [EMAIL PROTECTED] > Subject: Re: WIC-1ADSL, Qwest DSL [7:41713] > > > I know this doesn't help, but I have covad dsl and have been trying to use a > 1750 on the > other end of my speedstream to do ios firewall... I can't get that to work > either. When > I do a debug all,... and after I dig through all the other crap... I keep > getting an > encapsulation mismatch and a no keepalive warning. > > Sure it doens't help, but doesnt it make you feel better you aren't alone? > > bk > > Matt Fisher wrote: > > > Anybody out there setup a WIC-1ADSL with Qwest DSL in Bridging mode. > > > > I've got a Cisco 2621 and want to bridge the ADSL connection with fa0/0 > (and > > NAT fa0/1). I'm able to get the ATM session up, but can't get IP traffic > to > > flow. > > > > Of the configs at: > > http://www.cisco.com/warp/public/794/ > > the one at: > > http://www.cisco.com/warp/public/794/wicadsl_rfc_6400irb.html > > looks like it is close to what I want, but the config as listed doesn't > > work. (Can't put the same IP address on two different interfaces.) > > > > Any thoughts... > > > > Matt Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=41785&t=41713 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
