Hi all,
CCIE Practical studies - Vol I book - EIGRP chapter says that the
bandwidth command used in serial interfaces should be set to a value
equal to the remote port speed to which the serial interface is
connected to.
For ex :
RTR 1 ---------------------------------- RTR 2
1.544 Mbps 64 Mbps
int
s0 int s0
bandwidth 64
bandwidth 1544
My question is - Is it not going to affect the other routing protocols
like OSPF where we set the bandwidth decides the cost of the outgoing
interfaces.
Can somebody shed some light on this please?
Thanks,
Rajesh
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=44055&t=44055
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
