I believe you need a frame-relay map statement for CLNS. Something like this...
frame-relay map clns 100 broadcast This should allow IS-IS to work over a point-to-multipoint FR NBMA network. If the network consists of a full or partial mesh I'd consider using mesh groups to limit LSP flooding. -Michael Cohen -----Original Message----- From: Cisco Nuts To: [EMAIL PROTECTED] Sent: 6/13/02 11:25 PM Subject: Isis in a Nbma environment?? [7:46538] Hello, Is there a special config for isis in a FR nbma environment....I cannot seem to find any examples on CCO......Just configuring ip router isis at the intf. config mode apparently does not work....CCO does not have much info. on isis either..... Thank you for your help. Regards My config: interface Serial0 bandwidth 20000 ip address 10.1.255.6 255.255.255.252 ip router isis encapsulation frame-relay frame-relay lmi-type ansi end _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp. Note: The information contained in this message may be privileged and confidential and protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting it from your computer. Thank you. ThruPoint, Inc. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=46574&t=46538 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]