Hi, I've seemed to have found a stange issue with IPX Eigrp when running it over a Frame Relay setup.
Using ver 12.0(9) of IOS. I can see the other router's IPX network when typing in the 'show frame-relay map' command but can't get IPX Eigrp to establish an adjacency at all. I've typed in all the necessary IPX networks into the IPX EIGRP router config and subseqently taken those networks out of the IPX router setup. Also, on this 'exact' same frame relay network I never had an issue with picking up IPX/RIP routes between the DTE routers about 10 mins prior to setting up IPX EIGRP. I run debugs and it appears that there's very little activity from IPX EIGRP. It also seems as the IPX EIGRP if it's totally dead but is defintely configured ! Disabled and enabled IPX Routing and re-established the IPX ROUTING identifier but no luck at all. It's a very simple Frame relay setup with 3 router's and one is the FR switch. Each connection into the switch has it's own separate serial interface so I wouldn't expect a split-horizon issue to be the cause of the problem. Any ideas as to why IPX EIGRP does not like Frame Relay but loves HDLC ? Karen Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=46626&t=46626 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]