Everyone, Let me explain what I am trying to do. My main building was set up years ago with a Class C address scheme. I need to change this for a number of reasons and am planning to move it to a 10.X.X.X scheme. I would like to do this on a gradual basis.
My building contains the following equipment: 7206VXR router that does internal routing. I have one FastEthernet port on this router. One Catalyst 4006 (Sup2, set based code) switch on the third floor. Both these devices run the latest code. The first and second floors have Catalyst 3500 switches with fiber between floors. A VTP domain is set up between the 3 switches. It was suggested to me to put 3 subinterfaces on the fastethernet port on the router and then trunk them to the switch (or switches). I'm not quite sure of the best way to go about doing this. I've read numerous tac articles, but a little more guidance would be greatly appreciated. Here is a sample of the code I used on the 7206 to create the subinterfaces: interface FastEthernet0/0.1 encapsulation dot1Q 111 ip address 10.50.1.1 255.255.255.0 What do I do now? The router is plugged directly into port 4/10 on the 4006. Do I create a VLAN 111 on the 4006? Any replies can be copies directly to me at [EMAIL PROTECTED] as well as to the board. TIA Kris Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57772&t=57772 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]