""Kris Waters"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Everyone, > > Let me explain what I am trying to do. My main building was set up years ago > with a Class C address scheme. I need to change this for a number of reasons > and am planning to move it to a 10.X.X.X scheme. I would like to do this on > a gradual basis. > > My building contains the following equipment: > > 7206VXR router that does internal routing. I have one FastEthernet port on > this router. > > One Catalyst 4006 (Sup2, set based code) switch on the third floor. Both > these devices run the latest code. > > The first and second floors have Catalyst 3500 switches with fiber between > floors. A VTP domain is set up between the 3 switches. > > It was suggested to me to put 3 subinterfaces on the fastethernet port on > the router and then trunk them to the switch (or switches). I'm not quite > sure of the best way to go about doing this. I've read numerous tac > articles, but a little more guidance would be greatly appreciated. > > Here is a sample of the code I used on the 7206 to create the subinterfaces: > interface FastEthernet0/0.1 > encapsulation dot1Q 111 > ip address 10.50.1.1 255.255.255.0 > > What do I do now? The router is plugged directly into port 4/10 on the 4006. > Do I create a VLAN 111 on the 4006? Any replies can be copies directly to me >
CL: the 4006 port in question should also be configured as a dot1q trunk. at [EMAIL PROTECTED] as well as to the board. > > TIA > Kris Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57776&t=57772 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
