I noticed that on my 4006, I could only have isl enabled on the first 2 gige ports. It took me 2 calls to tac to wor this out, by default all were dot1q..
Hope this helps.. -----Original Message----- From: Mark Johnson [mailto:[EMAIL PROTECTED]] Sent: Monday, 23 December 2002 10:21 AM To: [EMAIL PROTECTED] Subject: Re: ISL & 802.1q in one switch [7:59512] Yes, it is possible... It is dependant upon the type of switch you are using... If it is a 3550, 2950, 4000, etc... You would do switchport mode trunk switchport trunk encapsulation (dot1q or isl) This is off the top of my head, so verify the exact syntax... Not all switches support both so you will need to check your hardware and software... Mark -------Original Message------- From: "[EMAIL PROTECTED]" Sent: 12/19/02 04:09 AM To: [EMAIL PROTECTED] Subject: ISL & 802.1q in one switch [7:59512] > > Hi folks, Does anybody have experience with using ISL en 802.1q within the same switch. I have ISL trunk between my access and distribution layer. Now I want to connect a firewall on my access switch with 802.1q trunking protocol. Is it possible? if the answer is YES, should I change anything in my configuration? My firewall talks 802.1q with the access switch and the vlan's should go from access to distribution switch which talk ISL. thanks, Mehrdad ********************************************************************** visit http://www.solution6.com UK Customers - http://www.solution6.co.uk ********************************************************************** The Solution 6 Head Office and Branch in Sydney is moving premises. >From Monday 25th November our Head Office and NSW Branch will be located at: Level 14, 383 Kent Street, Sydney NSW 2000. General Phone: 61 2 9278 0666 General Fax: 61 2 9278 0555 ********************************************************************** This email message (and attachments) may contain information that is confidential to Solution 6. If you are not the intended recipient you cannot use, distribute or copy the message or attachments. In such a case, please notify the sender by return email immediately and erase all copies of the message and attachments. Opinions, conclusions and other information in this message and attachments that do not relate to the official business of Solution 6 are neither given nor endorsed by it. ********************************************************************* Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=59731&t=59512 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
