If you ping you are probably pinging the Local IP.Try debug ip icmp to verify what you are pinging.
Daniel Ladrach CCNP, CCNA WorldCom -----Original Message----- From: Monu Sekhon [mailto:[EMAIL PROTECTED]] Sent: Monday, February 10, 2003 12:03 PM To: [EMAIL PROTECTED] Subject: RE: Simple Ip issue (need help) [7:62728] Hi All, Thanx again for all for contribution confusion still there , I am pinging remote side and I am able too. any comments from all(still confused with answers) Walker, James - Is wrote: > > Only problem is which side are you pinging???????? > > > > > -----Original Message----- > From: John Murphy [mailto:[EMAIL PROTECTED]] > Sent: Monday, February 10, 2003 11:15 AM > To: [EMAIL PROTECTED] > Subject: Re: Simple Ip issue (need help) [7:62728] > > > If you're asking what I think you're asking, then I think your > answer is > yes, but you won't be able to pass any traffic across the > circuit. Unless > you've confused me (it doesn't seem I would be the only one), > then the > answer might not be the same. > > > ----- Original Message ----- > From: "Monu Sekhon" > To: > Sent: Monday, February 10, 2003 12:13 AM > Subject: Simple Ip issue (need help) [7:62728] > > > > Hi All, > > I have very simple question, Can we use duplicate ips on > serial interfaces > > among them seleves although we cannot use duplicate ip on > serial with > > Ethernet(lan interface) or loopback interface. > > > > > > My topology is like this > > > > Client router server router(connected back to back) > > 2 interfaces 2 inetrfaces > > > > > > these routers connected back to back > > > > > > configuration > > int serial 0/0 > > encap hdlc > > ip address 1.1.1.1 255.255.255.0 > > > > int serial 0/1 > > ip address 1.1.1.1 255.255.255.0 > > encap hdlc > > > > > > > > now if all the two interfaces of serial even if given > duplicate ip among > > themselves works fine. no error from cli .interfaces are up > > and i am able to ping remote side. > > > > > > > > The ques is that > > > > 1) Lan interface also was in different subnet but serial > interface > > doesnot accept that ips as duplicate or of loopback > > > > 2)What Implication such have on my design ,any limitation it > has > > > > Does this type of design can be used, > > > > This is small thing is confusing me about ip. > > > > Thanx in advance Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62765&t=62728 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
