Hello, Does any one know why if 2 routers configured back-to-back for frame relay point-to-point intf. using different dlci's does NOT work? Unless, they are defined the same on both routers, does it work!! Here is my config: R5#ri s1.1 Building configuration...
Current configuration : 147 bytes ! interface Serial1.1 point-to-point ip address 1.1.1.1 255.255.255.0 ip router isis frame-relay interface-dlci 102 clns router isis end R5# R6#ri s0.1 Building configuration... Current configuration : 200 bytes ! interface Serial0.1 point-to-point ip address 1.1.1.2 255.255.255.0 ip router isis ip pim sparse-dense-mode frame-relay interface-dlci 102 clns router isis isis circuit-type level-1 end R6#ping 1.1.1.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/36 ms R6# Now change the dlci # on R6: R6#ri s0.1 Building configuration... Current configuration : 200 bytes ! interface Serial0.1 point-to-point ip address 1.1.1.2 255.255.255.0 ip router isis ip pim sparse-dense-mode frame-relay interface-dlci 201 clns router isis isis circuit-type level-1 end R6#ping 1.1.1.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: .... Success rate is 0 percent (0/5) R6# Can any one explain?? Thank you. Sincerely, CN _________________________________________________________________ Help STOP SPAM with the new MSN 8 and get 2 months FREE* http://join.msn.com/?page=features/junkmail Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=65355&t=65355 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
