I think the iron method may work. The heat will soften the glue and the iron would press it down. There is no way to clamp it flat on the wall. Good luck-Bill Sterling In a message dated 11/6/2012 3:54:23 P.M. Eastern Standard Time, rothassocia...@verizon.net writes:
I hope someone on the list may have a suggestion as to how to address/fix my problem. Sometime during the last month or so, water must have gotten into the boat from the deck as yesterday while cleaning up below, I found several blisters/delamination of the teak veneer on the upper far port side of the forward bulkhead in the main cabin. This situation has developed since late August which was the last time I wiped down the bulkhead. I’m not sure where the water got in as, except for the handrail which is not exactly over the blistered area and where I have never had any leaks in the 20 years I’ve owned the boat, there aren’t any fittings, cleats, etc. on the cabin top over the bulkhead between the mast and the side of the cabin. The blisters are tear drop shaped, wider at the top where the bulkhead meets to top of the cabin and narrowing down to almost a point. They extend in from the side of the cabin about 8-10 inches and one or two of them are 6 inches long or so. The blisters are only on the aft side of the bulkhead close to the side of the cabin. There doesn’t seem to be any problem with the same area on the other side of the bulkhead in the head. The area is dry now. Although I couldn’t reach to the very top of the bulkhead since the cabin liner is in the way, it appears that the plywood under the teak veneer is solid and there are no signs of rot or moisture on either side of the bulkhead in the affected area. The interior veneer on the boat has been varnished. By pressing on the blisters, it seemed like they could be pressed back flat against the plywood backing. I realize my first challenge will be to find out where the water is coming from, but I would appreciate any suggestions as to how these blisters might be repaired. I know that blistered veneers on furniture can sometimes be removed by heating with an iron, but that supposes that the veneer is applied with a heat sensitive glue. I suspect that the veneer that C&C used might have been glued with something like contact cement because of its intended use in a marine environment. I will be very grateful for any comments or suggestions as to how to deal with the blistered veneer after I’ve traced down the source of the water. Thanks, Art Roth C&C 36 Godspeed Palmetto, FL _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
