Drill and tap it.. Will take minutes and your done...
On Sat, Aug 3, 2013 at 12:42 PM, Dr. Mark Bodnar <drbod...@accesswave.ca>wrote: > I don't think you want a "hammer drill" - technically that is a drill > that hammers forwards and backwards at high speeds to break through > concrete. > I think what you want is an impact gun (similar to what mechanics use on > tire lug nuts - but available in small scale "drill" type versions) - that > will apply a certain amount of pressure with each impact, but not spin at > the high speed until the fastener is free. > > Mark > > --------------------- > Dr. Mark Bodnar > B.Sc., D.C., FCCOPR(C) > Bedford Chiropracticwww.bedfordchiro.ca > --------------------- > > There is no cure for birth and death save to enjoy the interval. > - George Santayana > > On 03/08/2013 11:13 AM, kelly petew wrote: > > I want to add a "T" track slide to my mast for a whisker pole. The mast > tracking is in place, but I can't break the bottom fastener, in order to > install the T-Track. Likely, corrosion b/t the fastener and mast is the > issue. > > Has anyone had any experience - good or bad - using a hammer drill to > break the corrosion bond?? > > > > thanks. > > > > > Pete W. > C&C30 MKII > > > _______________________________________________ > This List is provided by the C&C Photo > Albumhttp://www.cncphotoalbum.comcnc-l...@cnc-list.com > > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > > -- “The pessimist complains about the wind; the optimist expects it to change; the realist adjusts the sails.”
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
