We also have this same Gardena 4 way Manifold. Ken H.
On 28 May 2015 at 12:45, Kevin Driscoll via CnC-List <cnc-list@cnc-list.com> wrote: > I have the same Gardenia 4 way manifold with the same labels on my 89 > 30-2. Must have come from the factory that way? > > On Thu, May 28, 2015 at 7:28 AM Mitchell's via CnC-List < > cnc-list@cnc-list.com> wrote: > >> Josh, The valve on our 37+ was made by Gardenia and its a 4-1 if that >> helps. (I converted the port side fresh water tank to a holding tank for >> the Great Lakes, we have lots of room with two holding tanks.) >> Tom, it hasn't been said yet, and you probably already know but there is >> a Quest compression fitting end that goes on the plastic pipe with a SS >> ring and you can tighten the nut down pretty tight! The nut squeaks all the >> way tight and will take quite a bit of abuse. The plumbing is not in the >> sunlight and will last decades. If I was going to change it up and had a >> pile of spare cash to burn, I would go Pex too. They can use a two wrench >> snug but not very often. RVs have been using it forever too. >> Len >> Crazy Legs >> 1989 37+ >> >> >> >> Sent from my mobile device._______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com