Thanks; but I was thinking more of the actual steps of removing the old line and putting the new one in. I.e. where are the set screws? Do I need to take the drum off? Any special tools needed? etc.
On my old boat, I had a Furlex and it was simple – there was a set screw (you needed a torx driver) and that’s it. On this one, I have a problem finding how the line is attached. Marek From: David via CnC-List Sent: Wednesday, July 22, 2015 10:36 AM To: CNC CNC Cc: David Subject: Re: Stus-List replacing furling line I used simple dacron braided and stripped the core for the line that wraps on the furling drum. It helps lay the line flat and reduces problems in the drum. David F. Risch 1981 40-2 (401) 419-4650 (cell) -------------------------------------------------------------------------------- To: cnc-list@cnc-list.com Date: Wed, 22 Jul 2015 10:06:48 -0400 Subject: Stus-List replacing furling line From: cnc-list@cnc-list.com CC: dziedzi...@hotmail.com I need to replace the furling line in my Harken Unit 00 furler. I have the manual, but the instructions are very vague. I would appreciate any hints, if anyone of you have done this before. One more thing: the instruction call for securing the line with a “hog ring”. Is there an easy way of doing it? I am not about to buy a special tool and a load of 1000 fasteners to use just one. thanks for your help Marek C270, “Legato” in Ottawa _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com -------------------------------------------------------------------------------- _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
