On my Harken furler the line goes down through a small hole near the
center of the rope drum, I just feed it through and put a figure eight
knot in it. The knot has to be tight to fit into the space below the
drum, but that's all there is to it.
Neil Gallagher
Weatherly, 35-1
Glen Cove, NY
On 7/22/2015 11:29 AM, Marek Dziedzic via CnC-List wrote:
Thanks; but I was thinking more of the actual steps of removing the
old line and putting the new one in. I.e. where are the set screws? Do
I need to take the drum off? Any special tools needed? etc.
On my old boat, I had a Furlex and it was simple -- there was a set
screw (you needed a torx driver) and that's it.
On this one, I have a problem finding how the line is attached.
Marek
*From:* David via CnC-List <mailto:cnc-list@cnc-list.com>
*Sent:* Wednesday, July 22, 2015 10:36 AM
*To:* CNC CNC <mailto:cnc-list@cnc-list.com>
*Cc:* David <mailto:davidrisc...@msn.com>
*Subject:* Re: Stus-List replacing furling line
I used simple dacron braided and stripped the core for the line that
wraps on the furling drum. It helps lay the line flat and reduces
problems in the drum.
David F. Risch
1981 40-2
(401) 419-4650 (cell)
------------------------------------------------------------------------
To: cnc-list@cnc-list.com
Date: Wed, 22 Jul 2015 10:06:48 -0400
Subject: Stus-List replacing furling line
From: cnc-list@cnc-list.com
CC: dziedzi...@hotmail.com
I need to replace the furling line in my Harken Unit 00 furler. I have
the manual, but the instructions are very vague. I would appreciate
any hints, if anyone of you have done this before.
One more thing: the instruction call for securing the line with a "hog
ring". Is there an easy way of doing it? I am not about to buy a
special tool and a load of 1000 fasteners to use just one.
thanks for your help
Marek
C270, "Legato"
in Ottawa
_______________________________________________ Email address:
CnC-List@cnc-list.com To change your list preferences, including
unsubscribing -- go to the bottom of page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
------------------------------------------------------------------------
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the
bottom of page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
