I assume your Maxprop is a 3 blade? I have that setup on my 34+ with the same engine. At 2700 rpm we do about 6.5 to 6.75 knots pretty regularly, No issues with vibration, seems to be good power and good reverse power. Sorry I don't know offhand the pitch or size of the prop. That's my Maxprop experience, FWIW. Cheers
From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Dr. David Montgomery via CnC-List Sent: Sunday, August 02, 2015 10:51 PM To: cnc-list@cnc-list.com Cc: Dr. David Montgomery Subject: Re: Stus-List Best prop for 34+ Jim, I just dropped my prop off at PYI to be looked over. Mine was still working but one blade was a nasty orange color and the hub had lost a lot of material. though not enough to not keep it together. How bad was yours that was repairable? Dave M. On Aug 2, 2015, at 10:45 PM, Jim Watts via CnC-List <cnc-list@cnc-list.com> wrote: I had the same deal with my MaxProp, except all my zincs fell off. This was before I was Enlightened to dead-blow hammers and critical painting of zincs. It cost $500 US, but the guys at PYI did a great job of rebuilding the prop. Two weeks and half a boat unit is a cheap option. Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 2 August 2015 at 22:24, Dr. David Montgomery via CnC-List <cnc-list@cnc-list.com> wrote: It appears that the zincs got replaced on my drive shaft but not my Maxprop!!! Needless to say my prop is shot and I am looking at either another of the same or other options. I am hoping that some one out there with the same or similar boat can weigh in on whether the Maxprop or something else is recommended. I have a 3GM30 and ever since I bought this boat several years ago I have felt there was a bit too much vibration and not enough speed. If I take the engine up to about 2700 rpm's my boat speed is only around 5 to 5 1/4 knots. The prop has always performed adequately but not great. Maybe the pitch etc. is off. Looking also at the Variprop which supposedly has the least drag of all 3 blades and can be adjusted much easier than the Maxprop. Thoughts, ideas, what are you other 34+ owners using? Thanks, Dave M. _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com