Is it a Yanmar? If so, try running a temporary dedicated wire from the "I" connection on the ignition switch or the positive side of the starter button to the solenoid. If it starts strongly, make the wire permanent bypassing the harness near the engine.
-- Dennis C. Touche' 35-1 #83 Mandeville, LA On Fri, Jul 3, 2020 at 1:22 PM General Gao via CnC-List < cnc-list@cnc-list.com> wrote: > Hi everyone, > > I usually have to turn the key a few times for the starter to actually > rotate. I can hear the solenoid clicking even when the starter does not > turn. > > Would this indicate it is just a wire or connector issue? Or a starter > issue? Or if further investigation needed, what should be looked at? > > Just want to see if I can get advice from the much more experienced > community. > > thank you, > > Bo > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
