Hi, If the soleonid moves but motor does not turn it may well be the
solenoid itself, assuming all high amperage connexions are clean and tight .
When this happens and a screwdriver between the 2 + posts make it work then it
is the connexion between the 2 posts inside the solenoid.
beware of sparks when you perform tests ( I have an Atomic 4 )
SylvainC&C27 MkIII
On Friday, July 3, 2020, 2:22:46 PM EDT, General Gao via CnC-List
<cnc-list@cnc-list.com> wrote:
Hi everyone,
I usually have to turn the key a few times for the starter to actually rotate.
I can hear the solenoid clicking even when the starter does not turn.
Would this indicate it is just a wire or connector issue? Or a starter issue?
Or if further investigation needed, what should be looked at?
Just want to see if I can get advice from the much more experienced community.
thank you,
Bo_______________________________________________
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use PayPal
to send contribution -- https://www.paypal.me/stumurray
_______________________________________________
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use PayPal
to send contribution -- https://www.paypal.me/stumurray
