Thank you, but no, it doesn't help. My card is a different card than the realport. It uses the [xircom_cb_tulip?] driver (I'm not exactly sure what it's called, but it's something like this, with tulip in it. -- It's a tulip work-alike?) Rich
Robert Fox wrote: > > On Fri, 2002-03-08 at 22:48, root wrote: > > As with every Mandrake preliminary release so far, the Xircom Cardbus > > Ethernet/Modem is not recognized during setup of the network. The module > > loads, as evidenced in the "Detected Hardware" window available when the > > setup program asks about SCSI drives. When I get to the part about > > setting up network cards, though, it doesn't detect any ethernet > > devices. Cardbus pcmcia ethernet cards are not in the list of cards > > available for manual setup. > > > > I have a Xircom Realport Cardbus (RBEM-56G) and it works fine during > install. My only problem is (as reported several times) is that after > install, every new boot I only get half-duplex (not full-duplex like > during the pcmcia.img install!) I doubt this will be fixed even though > I've reported it several times. > > The module that loads for the xircom cards is usually: > xircom_cb > yenta_socket > > Hope this helps, > R.Fox