Hi Ada,
An A to A Cable works fine. I think you don't have to change the jumper
j7, because it's only for signal termination.
But i'm not sure... Rebuilding a new kernel with usb device enabled is
the key...
Regards,
Patrik
to A CabAdarsha K.S schrieb:
Thanks Patrik.
What about the jumper setting and the connector? Changing only the
jumper j7 would make it slave? Or any other changes needed?
Regards,
Ada
------------------------------------------------------------------------
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
