Thanks Patrik. With A connector it is working. I have selected the File Backed Storage gadget. I insert the module by insmod g_file_storage.ko file=/home/testfile. The module will be loaded. I have formatted the testfile using fdisk. But when I connect the board to Windows host, The host will recognize the device as a mass storage device. But the drive will not appear in windows and the board will crash. Can anyone please tell me why it is happening? Is it problem with the driver?
Regards, Ada -----Original Message----- From: Patrik Nagel [mailto:[EMAIL PROTECTED] Sent: Tuesday, January 23, 2007 12:41 PM To: Adarsha K.S Cc: [email protected] Subject: USB device Hi Ada, An A to A Cable works fine. I think you don't have to change the jumper j7, because it's only for signal termination. But i'm not sure... Rebuilding a new kernel with usb device enabled is the key... Regards, Patrik to A CabAdarsha K.S schrieb: > > Thanks Patrik. > > > > What about the jumper setting and the connector? Changing only the > jumper j7 would make it slave? Or any other changes needed? > > > > Regards, > > Ada > > > > > > ------------------------------------------------------------------------ > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
