This one worked. Thank you very much. Eric
"Karl B. Hammar" wrote: > > Your message says me that the 7000FASST might not be the cause of the > problem. > > Well, try this one then > > # cp .config.save .config > # make menuconfig # remove all compiled in SCSI support except aic7xxx > # make dep; make clean; make zImage > # mv arch/i386/boot/zImage vmlinuz-2.0.36-only-aic7xxx > > available as ftp://kalle.csb.ki.se/pub/vmlinuz-2.0.36-only-aic7xxx > > # cp /.../disks-i386/2.1.9-1999-03-03/resc1440.bin . > # cp resc1440.bin resc1440.bin-only-aic7xxx > # mount -o loop resc1440.bin-only-aic7xxx /mnt > # cp vmlinuz-2.0.36-only-aic7xxx /mnt/linux > # /mnt/rdev.sh > + set -e > + readonly Arch=i386 > + Arch=i386 > + '[' i386 '!=' m68k ']' > + rdev -R /mnt/linux 1 > + rdev -r /mnt/linux 0 > + rdev -v /mnt/linux -1 > + rdev /mnt/linux /dev/ram0 > # umount /mnt > > available as ftp://kalle.csb.ki.se/pub/resc1440.bin-only-aic7xxx > > To save download time, get vmlinuz-2.0.36-only-aic7xxx and do part two > yourself. > > If this does not work, hmm, big problems > If this do work, let us include more SCSI support and iterate till we find > the one cousing the conflict. > > Cheers, > Karl > > ------------------------------------------------------------------------------- > Karl Hammar Aspö Data [EMAIL PROTECTED] > Lilla Aspö 2340 0173 140 57 > S-742 94 Östhammar 070 511 97 84 Professionella Linuxlösningar > Sweden > ------------------------------------------------------------------------------- > > On Wed, 16 Jun 1999, Eric wrote: > > > It failed. I booted using 4 different boot prompt parameters: none; > > aic7xxx=no_probe; aic7xxx=no_reset; and aic7xxx=no_probe,no_reset. All > > four times, the system froze after the "419 instructions downloaded..." > > line, for a good minute, which I interpreted as failure. Any more > > suggestions? I really want to get Linux running. > > > > Eric > > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
