On Fri, Jan 04, 2008 at 11:06:31PM +0100, David MAGNY wrote: > Hello, > > I am upgrading a firewall from Sarge to Etch. > > On this machine, I have 3 network cards. > > 2 networks cards are identical. It is PCI network > cards and it is SMC1233A-TX. > > On Sarge, everything worked well. > > The issue is that only one card of both is available. > The used kernel is 2.6.18. > > Within the dmesg log file, I have the following > information : ... > e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network > Connection
found 1 card, though it's not very helpful info. ... > eth1: ADMtek Comet rev 17 at 0001c800, > 00:50:BF:B0:CB:4B, IRQ 217. ... found another card, with MAC and irq. > eth2: ADMtek Comet rev 17 at 0001cc00, > 00:50:BF:B7:F2:79, IRQ 225. ditto. ... > ADDRCONF(NETDEV_UP): eth2: link is not ready > e1000: eth2: e1000_watchdog: NIC Link is Up 100 Mbps > Full Duplex > ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready hmmm... do the ADMtek cards use e1000 driver or did eth0 get moved to eth2, thus bumping eth2 elsewhere? > > > > I noticed that the two identical network cards are > detected : > > eth1: ADMtek Comet rev 17 at 0001c800, > 00:50:BF:B0:CB:4B, IRQ 217. > ACPI: PCI Interrupt 0000:03:0d.0[A] -> GSI 49 (level, > low) -> IRQ 225 > tulip1: MII transceiver #1 config 1000 status 786d > advertising 05e1. > eth2: ADMtek Comet rev 17 at 0001cc00, > 00:50:BF:B7:F2:79, IRQ 225. > > I added the following parameters to the kernel > pci=irprouting, and I always have the same issue. why did you do this? is that a typo? irqrouting maybe? what output from lspci -v what output from ls /sys/bus/pci/drivers/ and ls /sys/bus/pci/drivers/e1000 A
signature.asc
Description: Digital signature