Do I need to use gnuradio - companion for transmission and reception of the data packets or the benchmark_tx.py commands from the terminal would be enough for that to happen. I am unable to sort out. Kindly help.
Regards, Dave On Sep 16, 2015 2:59 PM, "Rama V" <ramav...@gmail.com> wrote: > ---------- Forwarded message ---------- > From: "Rama V" <ramav...@gmail.com> > Date: Sep 15, 2015 7:47 PM > Subject: Re: Transmission error > To: <discuss-gnuradio@gnu.org> > Cc: > > Please kindly help with the above error > > Thanks, > Dave > On Sep 14, 2015 5:02 PM, "Rama V" <ramav...@gmail.com> wrote: > >> Hey all, >> I have a small doubt regarding the reception of data packets. I am >> attaching a small figure of the command 'uhd_fft' where I mentioned the >> frequency and the sampling rate as 250k. The command I have given for this >> was >> >> ./benchmark_tx.py -m qpsk -M 2 --discontinuous -f 2.435G >> >> I tried to run this and I see an 'U' in the middle of transmission. Is >> this why I was not able to receive the packets because I get >> >> ok = False pktno = 53034 n_rcvd = 1 n_right = 0 >> >> My PC is Dell Inspiron 15R 5537 and I think it's somewhat a new version. >> Do I need to mention any sample rate in the command of benchmark. And also >> when I set the sample rate to 250k in my benchmark command, my laptop >> freezes and I need to restart it again. Do I need to give a low value? >> Please help and excuse for my brevity. >> >> Thanks, >> Dave >> >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio