On 02/03/2024 18:07, Robert Sharp wrote:
On 02/03/2024 16:29, Simon Kelley wrote:
I think you probably need start and end addresses in the dhcp range
dhcp-range=::1,::400,constructor:enp3s0,24h
without a range of addresses, dnsmasq can't lease addresses and will
only do stateless DHCPv6 and RA.
There's loads more information out there that will help if you set
--log-dhcp in your dnsmasq config and look in the syslog. That will
tell you is dnsmasq has managed to construct an actual dhcp range
from the address on enp3s0 and allow you to see if it's getting
SOLICIT packets and what it's doing in response.
The output from ip addr show dev enp3s0 would be useful too. Look at
the address, prefix length and lifetimes.
Simon.
Thanks, Simon. I will try both of your suggestions. At least the
--log-dhcp should get me further if the end address does not work.
Robert
Just to say that adding the end address fixed the problem. Thanks for
your help.
Robert
_______________________________________________
Dnsmasq-discuss mailing list
Dnsmasq-discuss@lists.thekelleys.org.uk
https://lists.thekelleys.org.uk/cgi-bin/mailman/listinfo/dnsmasq-discuss