This series collects fixes for the RK3588 VOP2 found while bringing up HDMI and DisplayPort output on an Orange Pi 5 (RK3588S).
Patches 1 and 2 fix the RK3588 interface setup: rk3588_calc_cru_cfg() leaves dividers it does not use uninitialised and the garbage ends up in VP_CLK_CTRL, and rk3588_get_hdmi_pol() decodes the POLFLAG bits it is handed as DRM mode flags, so the GRF sync polarity bits are wrong for most modes. Patch 3 stops the RK3588 Cluster windows from advertising AFBC with the lossless colour transform (YTR) for RGB565/BGR565, which the decoder cannot display (black picture plus POST_BUF_EMPTY). Patches 4 and 5 deal with POST_BUF_EMPTY underflows. The VOP2 fetches through two AXI read ports but the port of each window is fixed in the window table, so the usual primary plane plus overlay configuration of a video port puts both layers on one port while the other sits idle. One port cannot sustain two full screen 4K@120Hz layers (measured: the fetch rate collapses from ~6 GB/s to ~3 GB/s and about half of all lines underflow). Patch 4 assigns the port when a window starts fetching, balancing the estimated load; patch 5 rate-limits the POST_BUF_EMPTY interrupt to once per frame, since an underflowing port otherwise keeps the CPU in the interrupt handler 50000 to 300000 times per second. Patches 6 to 8 are smaller fixes: the start mixer search skipped Esmart3 (for_each_set_bit() was given the highest window id as the bit count), a gamma LUT update cleared the other fields of LUT_PORT_SEL (the VP0/VP2 dclk source selection and the VP0/VP1 merge enable), and the AFBC tile count and transform offset were wrong for a source that starts inside a 16 pixel superblock. Tested on an Orange Pi 5 (RK3588S) with an HDMI 2.1 TV and a DisplayPort monitor, pictures judged with a camera. Patches 1 and 2: VP0_CLK_CTRL reads back without the garbage dclk_out divider, the sync polarities seen by the HDMI controller (VIDEO_INTERFACE_STATUS0) match the mode flags for +/+ (1080p, 2160p) and -/- (720x480, 640x480) modes, and the picture is correct over TMDS and FRL modes from 27 to 1188 MHz. Patch 3: RGB565 is offered on the Cluster windows only without YTR, and those planes scan out correctly on three Cluster windows. Patches 4 and 5: 3840x2160@120 with a full screen overlay (previously ~120000 POST_BUF_EMPTY per second and a scrambled picture) and a dual-display session (HDMI 4K@60 plus DP 4K@30, two video players, ten minutes) run with zero underflows. Patches 6 to 8 were found while driving Esmart3 and partial AFBC overlays: an AFBC overlay placed at x=1001 shows correctly. All eight have been in the board's kernel for the display test runs since. This series was developed with Claude (Anthropic) as a coding assistant: it wrote the code and the commit messages, and I reviewed and tested every change as described above. Signed-off-by: Arun Iyengar <[email protected]> --- Arun Iyengar (8): drm/rockchip: vop2: Don't use uninitialised dividers on RK3588 drm/rockchip: vop2: Fix the HDMI sync polarity on RK3588 drm/rockchip: vop2: Don't accept AFBC YTR for RGB565 on RK3588 drm/rockchip: vop2: Balance window fetches across both AXI ports on RK3588 drm/rockchip: vop2: Report POST_BUF_EMPTY at most once per frame drm/rockchip: vop2: Find the first mixer of a video port with Esmart3 too drm/rockchip: vop2: Keep the other LUT_PORT_SEL fields on gamma LUT updates drm/rockchip: vop2: Fix the AFBC offsets of a source that starts inside a superblock drivers/gpu/drm/rockchip/rockchip_drm_vop2.c | 186 +++++++++++++++++++++++++-- drivers/gpu/drm/rockchip/rockchip_drm_vop2.h | 24 ++++ drivers/gpu/drm/rockchip/rockchip_vop2_reg.c | 27 +++- 3 files changed, 223 insertions(+), 14 deletions(-) --- base-commit: 8deaade4a5a4ff635df91e246e42139ab2b33f6d change-id: 20261110-vop2-fixes-fa45142799c1 Best regards, -- Arun Iyengar <[email protected]>
