Thank you for your contribution! Sashiko AI review found 1 potential
issue to consider:
- [Low] drm/bridge: analogix_dp: inaccurate RK3288 PHY comment in
  analogix_dp_probe()
--

commit 720fa3eab5052c038874ca588f7e1541886e6915
Author: Jun Yan <[email protected]>

drm/bridge: analogix_dp: use devm_phy_optional_get() for the DP PHY

This commit replaces devm_phy_get() and its open-coded error handling with
devm_phy_optional_get() in analogix_dp_probe() when acquiring the optional
DP PHY.

> diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c 
> b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> index 8bb4c48aa3b48..09171c6605d0b 100644
> --- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> +++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> @@ -1427,21 +1427,13 @@ analogix_dp_probe(struct device *dev, struct 
> analogix_dp_plat_data *plat_data)
>       if (ret)
>               return ERR_PTR(ret);
>  
> -     dp->phy = devm_phy_get(dp->dev, "dp");
> -     if (IS_ERR(dp->phy)) {
> -             dev_err(dp->dev, "no DP phy configured\n");
> -             ret = PTR_ERR(dp->phy);
> -             if (ret) {
> -                     /*
> -                      * phy itself is not enabled, so we can move forward
> -                      * assigning NULL to phy pointer.
> -                      */
> -                     if (ret == -ENOSYS || ret == -ENODEV)
> -                             dp->phy = NULL;
> -                     else
> -                             return ERR_PTR(ret);
> -             }
> -     }
> +     /*
> +      * RK3288/RK3399 use Analogix DP controller built-in PHY,
> +      * no extra PHY configuration is required.
> +      */
> +     dp->phy = devm_phy_optional_get(dp->dev, "dp");
> +     if (IS_ERR(dp->phy))
> +             return ERR_CAST(dp->phy);

[Severity: Low]
Are this comment and the commit message accurate about RK3288?

In arch/arm/boot/dts/rockchip/rk3288.dtsi and
Documentation/devicetree/bindings/display/rockchip/rockchip,analogix-dp.yaml,
the RK3288 eDP node defines phys = <&edp_phy> and phy-names = "dp" for its
rockchip,rk3288-dp-phy device, which drivers/phy/rockchip/phy-rockchip-dp.c
programs via GRF_SOC_CON12 when phy_power_on() and phy_power_off() are
called on dp->phy.

RK3399 and RK3568 are the variants that omit the phys property and configure
the built-in PHY directly through the controller MMIO registers rather than
through a separate PHY device or GRF.

-- 
Sashiko AI review ยท 
https://sashiko.dev/#/patchset/[email protected]?part=1

Reply via email to