Hi, On 14/11/2026 03:05, Jiaxing Hu wrote: > Each core is on its own power domain only: core 0 on PD_NPU0, core 1 on > PD_NPU1. Measured with both cores running, the results are correct, and > the nputop and npu domains above them are powered through the domain > hierarchy.
No need to include lab notes; we assume you tested this work and found it to be working before submission. > Label PD_NPU so a board can connect the NPU supply. The IOMMUs use four > clocks. > > Also set CLK_RKNN_DSU0 to 594 MHz. Mainline sets neither its rate nor the > NPU voltage. On the ROCK 4D the DSU runs at 786 MHz by default and the > rail boots at 750 mV; with both cores running, each pass of the 5400-row > test has 11 to 25 wrong words. At 594 MHz the test is all correct. In the > vendor OPP table, the 500 MHz and 600 MHz steps both need 725 mV. I found this wording a bit confusing. I think you're saying, the system boots into Linux with 786MHz & 750mV, and that configuration gives bad results. I'm not clear why you picked 594 Hz then. What does the vendor kernel do, are you matching that behaviour?
