Don, The following is part of an email exchange I had with WK6F about 18 months ago. He was able to get his KAM plus working with DX4WIN (using the null serial cable route) by using these control sequences.
Hope this helps you also, -larry K8UT -----Original Message----- From: Larry Gauthier (K8UT) [mailto:[EMAIL PROTECTED] Sent: Wednesday, October 29, 2003 03:42 To: [EMAIL PROTECTED] Subject: Re: [MMTTY] KAM emulation Ken, I use MMTTY in TNC241 emulation mode... primarily because that's what I could get to work with my DX4WIN logging program. (I run MMTTY and DX4WIN within one computer, with null modem software, so that they talk to each other with a "virtual" null modem cable). Disclaimer: I know nothing about KAM's cmd control codes -- but this is what happened when I hacked around with it -- As an experiment, I switched to KAM emulation. MMTTY sent the following screen and prompt to DX4WIN... ===== MMTTY Ver1.64 (C) JE3HHT 2000-2003. TNC emulation. Command 'RTTY' To RX:Ctrl+C,R To TX:Ctrl+C,T cmd: ===== >From that "cmd:" prompt, if I type "RTTY<enter>" I get a "-RTTY 45-" response from MMTTY. Then, if I type "<ctrl+C>R", receive character begin arriving in the emulation receive window. If I type "<ctrl+C>T the software kicks MMTTY into transmit mode and send whatever characters are in the outbound buffer. I can then toggle back-and-forth between rcv and xmt by using those control codes. If I type <ctrl+C>X, MMTTY halts emulation and returns to the "cmd:" prompt. Not sure if this helps you or not -- but if you have some specific tests you would like me to try send me an email off-line and we can hack at it. -larry K8UT =========================== From [EMAIL PROTECTED] Mon May 30 08:34:49 2005 From: [EMAIL PROTECTED] (Roger Borowski) Date: Mon May 30 08:46:11 2005 Subject: [Dx4win] rtty References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Don, With the KAM or KAMPlus in the terminal mode, at the command prompt, you type RTTY + "Enter" to get the KAM into the RTTY mode. Then %CT%M is the command for putting the TNC into the Transmit mode, and %CE is the command to return to the Receive mode. You can program a couple of function keys to do this for you, so you can just use one of the F keys to TX and another to RX. I think this is what you are looking for? 73, -=Rog-K9RB=- (312 DXCC entities now on RTTY here w/DX4WIN + KAMPlus TNC) ----- Original Message ----- From: "Don Taylor" <[EMAIL PROTECTED]> To: <dx4win@mailman.qth.net> Sent: Friday, May 27, 2005 2:33 PM Subject: [Dx4win] rtty Can any one tell me how to get rtty to tx useing a kam . Not mmtty, There is a command in the edit function keys to turn on the transmitter and to turn it off. I can't rember what it is.... Thanks Don W0DET _______________________________________________ Dx4win mailing list Dx4win@mailman.qth.net http://mailman.qth.net/mailman/listinfo/dx4win