Yes Under xp there is a change. You may have to reinstall DXB I did. But first, go to the help file. Select cw interface and then windows Registry entries. There are two sets, select the WinNt set and you will that under DriverX there is a key for Parameters. That is where the com port should be listed.
But the install can be painless. Save your log.mdb, refdata, any labels you may have changed and most important, the DXBase.ini file with is in Windows dir, to a safe place. Reinstall into the SAME directory as you had before. Then copy the previously saved file back and you will be in business. Then you can check in system for the new I/O addresses and make sure they are now correct in the registry. I had EXACTLY the same situation and it works perfectly now. ----- Original Message ----- From: "Alan K. Adamson" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, February 03, 2002 9:57 PM Subject: [DXBase] DXBASE 2002 with windows xp - need some help please > Well, I upgraded from winME to WinXP from a machine that had DXBASE 2002 > installed on it. Everything worked until I tried to talk to my rotator. > > It doesn't work. I did a little investigation and it appears that the > reg entries are not there for the "driverX/..." branch. > > I'd prefer not to have to reinstall if possible. Could someone export > that branch to a file and email it to me so that I can import it into my > reg. I can probably create the necessary portnames, etc, but I don't > have any idea what the keys need to be created as. > > Or, can I just reinstall? Will it keep my old settings? And fix this > problem? > > Thanks in advance. > Alan > > Ps. Please oh, please oh, please, put higher baud rate in 2003 for radio > and other control. 9600 make me adjust my radio everytime I want to > talk to it with dxbase after having talked to it with the kenwood > software. It's a TS2000 that support 57k6. > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase > >
