Greg: My Pro II works fine with DXBase and Writelog...you just need to get your settings correct.
Use 5Ch. 9600 baud. Do NOT use automatic. GL. 73, Al, K6RIM ---------- At 06:12 AM 3/7/2004, Greg - N4CC wrote: >OK, Jack -- I put the radio on 4800 baud (which I had tried anyway) but still >no joy...I don't see a baud rate setting in the radios.ini file. The baud >rate >that is set in "User Options, Radio 2 is 4800. So both the radio and DXBase >are set to 4800...Any other thoughts? Thanks/73 de Greg > >At 08:54 AM 3/7/2004 -0500, Jack wrote: > >Greg, > > > >A couple thoughts: > > > >1. You cannot use "autobaud" to interface with DXbase. DXbase expects your > >radio baudrate to be set to the same baudrate that you select in DXbase user > >options. If you have DXbase user options set to 4800, then you must also > >assign your radio baudrate to be 4800. > > > >2. The address that is set in the radio must agree with the address that is > >assigned in the DXbase radios.ini file. We recommend setting the radio to > >agree with the DXbase radios.ini file because if you change the radios.ini > >file, you would have to continue to "remember" to change any future versions > >of radios.ini since the address we use would not know about your change. > > > >Hope this helps, > >Jack > > > >----- Original Message ----- > >From: "Greg - N4CC" <[EMAIL PROTECTED]> > >To: <[email protected]> > >Sent: Sunday, March 07, 2004 8:45 AM > >Subject: [DXBase] IC-756 Pro II > > > > > >> Hi All -- anyone have any thoughts...I'm at my wits end trying to get my > >> 756 Pro II to interface with DXBase 2004. > >> Facts: > >> 1. I have two different Yaesu radios that both interface fine with DXBase > >2004 > >> 2. The Icom Radio interfaces with Writelog when I use 5Ch as the address > >> > >> I use 64h for the radio address with DXBase, and have the baud rate set to > >> "auto" as I do with Writelog... I am trying to use it as "radio 2" and > >> have the "radio 2" parameters set as 4800, 8, None, 1. DTR and RTS are > >> both checked and "enable radio 2" is checked. > >> > >> I tried going into DXBase Radios.ini file and changing the address to 5C > >> but no change. Changed it back to its initial 64h setting... > >> > >> So, I know the interface works and the radio work, because it works with > >> Writelog. What do I need to change to get it to work with DXBase? I know > >> some people have said that they are having success with their PRO > >> II's...Can you tell me how you have it set up and have you made any > >changes > >> with your port settings or with the radios.ini file? > >> > >> Thanks and 73 de Greg-N4CC > >> _______________________________________________ > >> DXBase Reflector - Please visit us on the web at www.dxbase.com > >> - - - - - - - - - - - - - - - - - - - - - - - > >> To UNSUBSCRIBE please visit: > >> http://mailman.qth.net/mailman/listinfo/dxbase > >> > >_______________________________________________ >DXBase Reflector - Please visit us on the web at www.dxbase.com >- - - - - - - - - - - - - - - - - - - - - - - >To UNSUBSCRIBE please visit: >http://mailman.qth.net/mailman/listinfo/dxbase
