RC, When you "click" on an incoming packet spot, a lot of things happen:
1. Previous QSOs with that station are displayed. 2. Band/Mode matrix is displayed showing where you have the country wkd/cfm. 3. Name of the country. 4. Beam heading 5. Distance. 6. Manager lookup and/or station address is displayed. 7. Previous notes for this callsign. During normal operation, most folks like being able to see all this just by a single click. So, we do not automatically turn the rotor. But, a second click starts it turning. Regards, Courtney ----- Original Message ----- From: "N3OP" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Thursday, June 10, 2004 12:03 PM Subject: [Dxbase] Rotor Control Hi, I am thinking about switch from DX4WIN to DXBase, but I have a question about the rotor interface. I use a Yaesu G800DX rotor, and I plan to interface it via RS-232 to DXBase. My question is, will my rotor turn when to the correct heading when I click on a spot in the DX Cluster, or will the rotor only turn by using the Rotor Toolbar ? RC _______________________________________________ Dxbase mailing list [email protected] http://mailman.qth.net/mailman/listinfo/dxbase
