Ken, I sort of remember something about band map planning using the internet, second radio and second rotor. Not sure if that is requirement or not for you.
In any case, I'll be connecting my second rotor in the near future and will let you and the reflector know if I see the same problem. My rotor is a Ham series with the Idiom press i/o. 73 Eric. - VE3GSI > -----Original Message----- > From: W8LU > > I have a two rotor setup, using a Yaesu G-2800DXA for rotor 1 > and a Yaesu G-800XA for rotor 2. Both rotors are computer > interfaced using Idom Press controller boards. I use a > Byterunner USB to serial port computer interface to obtain > the necessary number of serial ports. > > Computer control of rotor 1 via DXBase always works > flawlessly. My problem is with rotor 2. > > When I first set up rotor 2 in user options, it too works > flawlessly as long as I don't use rotor 1. After the first > time I control rotor 1 through DXBase, rotor 2 will no longer > function through the DXBase interface. > > If I then deactivate rotor 2 in DXBase user options, close > user options, reopen user options and then reactivate rotor > 2, it will once again function flawlessly - but only until I > use rotor 1 again. Then rotor 2 is non functional. > > Any ideas of what my problem might be? > > Thank you, > Ken W8LU
