On 2015-08-26 01:19, Rose, Gregory V wrote:
-----Original Message-----
From: Christian Ruppert [mailto:id...@qasl.de]
Sent: Friday, August 21, 2015 7:06 AM
To: Rose, Gregory V
Cc: e1000-de...@lists.sf.net
Subject: RE: [E1000-devel] X710 / i40e interface resets

On 2015-07-28 18:51, Rose, Gregory V wrote:
>> -----Original Message-----
>> From: Christian Ruppert [mailto:id...@qasl.de]
>> Sent: Tuesday, July 28, 2015 5:43 AM
>> To: Rose, Gregory V
>> Cc: e1000-de...@lists.sf.net
>> Subject: RE: [E1000-devel] X710 / i40e interface resets
>>

[snip]

> I've been told that the Tx driver issue detected message is due to a
> MDD (Malicious Driver Detection) event.  We need to find out what is
> causing that so if you could please send me your system log and the
> output of ethtool <intf> and ethtool -i <intf> perhaps I can see what
> might be occurring.  If not then we'll have to debug further.

See the initial Mail for ethtool -k and so on. Also:
# ethtool eth0
Settings for eth0:
        Supported ports: [ FIBRE ]
        Supported link modes:   1000baseT/Full
                                10000baseT/Full
        Supported pause frame use: Symmetric
        Supports auto-negotiation: No
        Advertised link modes:  1000baseT/Full
                                10000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: No
        Speed: 10000Mb/s
        Duplex: Full
        Port: FIBRE
        PHYAD: 0
        Transceiver: external
        Auto-negotiation: off
        Supports Wake-on: d
        Wake-on: d
        Current message level: 0x0000000f (15)
                               drv probe link timer
        Link detected: yes
# ethtool -i eth0
driver: i40e
version: 1.2.48
firmware-version: f4.33.31377 a1.2 n4.42 e191b
bus-info: 0000:02:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes

I also need the output of 'dmesg' - and I need to figure out how to
determine what specific MDD event is occurring.  I'll get back to you
with instructions on how to do that when I get the system log from
you.

See the attached file. It's a dmesg from boot + some minutes.
I'll upgrade the card's firmware tomorrow I guess and try out the new drivers btw.


Thanks,

- Greg

--
Regards,
Christian Ruppert
------------------------------------------------------------------------------
_______________________________________________
E1000-devel mailing list
E1000-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/e1000-devel
To learn more about Intel&#174; Ethernet, visit 
http://communities.intel.com/community/wired

Reply via email to