Attachments don't work on this mailing list (though they may have gotten to Greg). Please file a bug on e1000.sourceforge.net and attach the files there.
Todd Fujinaka Software Application Engineer Networking Division (ND) Intel Corporation todd.fujin...@intel.com (503) 712-4565 -----Original Message----- From: Christian Ruppert [mailto:id...@qasl.de] Sent: Wednesday, August 26, 2015 10:24 AM To: Rose, Gregory V Cc: e1000-de...@lists.sf.net Subject: Re: [E1000-devel] X710 / i40e interface resets On 2015-08-26 01:19, Rose, Gregory V wrote: >> -----Original Message----- >> From: Christian Ruppert [mailto:id...@qasl.de] >> Sent: Friday, August 21, 2015 7:06 AM >> To: Rose, Gregory V >> Cc: e1000-de...@lists.sf.net >> Subject: RE: [E1000-devel] X710 / i40e interface resets >> >> On 2015-07-28 18:51, Rose, Gregory V wrote: >> >> -----Original Message----- >> >> From: Christian Ruppert [mailto:id...@qasl.de] >> >> Sent: Tuesday, July 28, 2015 5:43 AM >> >> To: Rose, Gregory V >> >> Cc: e1000-de...@lists.sf.net >> >> Subject: RE: [E1000-devel] X710 / i40e interface resets >> >> > > [snip] > >> > I've been told that the Tx driver issue detected message is due to >> > a MDD (Malicious Driver Detection) event. We need to find out what >> > is causing that so if you could please send me your system log and >> > the output of ethtool <intf> and ethtool -i <intf> perhaps I can >> > see what might be occurring. If not then we'll have to debug further. >> >> See the initial Mail for ethtool -k and so on. Also: >> # ethtool eth0 >> Settings for eth0: >> Supported ports: [ FIBRE ] >> Supported link modes: 1000baseT/Full >> 10000baseT/Full >> Supported pause frame use: Symmetric >> Supports auto-negotiation: No >> Advertised link modes: 1000baseT/Full >> 10000baseT/Full >> Advertised pause frame use: No >> Advertised auto-negotiation: No >> Speed: 10000Mb/s >> Duplex: Full >> Port: FIBRE >> PHYAD: 0 >> Transceiver: external >> Auto-negotiation: off >> Supports Wake-on: d >> Wake-on: d >> Current message level: 0x0000000f (15) >> drv probe link timer >> Link detected: yes >> # ethtool -i eth0 >> driver: i40e >> version: 1.2.48 >> firmware-version: f4.33.31377 a1.2 n4.42 e191b >> bus-info: 0000:02:00.0 >> supports-statistics: yes >> supports-test: yes >> supports-eeprom-access: yes >> supports-register-dump: yes >> supports-priv-flags: yes > > I also need the output of 'dmesg' - and I need to figure out how to > determine what specific MDD event is occurring. I'll get back to you > with instructions on how to do that when I get the system log from > you. See the attached file. It's a dmesg from boot + some minutes. I'll upgrade the card's firmware tomorrow I guess and try out the new drivers btw. > > Thanks, > > - Greg -- Regards, Christian Ruppert ------------------------------------------------------------------------------ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel To learn more about Intel® Ethernet, visit http://communities.intel.com/community/wired