Dan,
Set the power at 6 watts, then adjust the audio drive so you get 5 watts
output. You can also watch the ALC, with the ALC/RF on ALC. It should
just begin to flicker on the far right hand side. Press and hold ANT 1/2
and TUNE to read power forward power/reflected power. The display should
read 6.0 F and 0.0r when your antenna it tuned up. Note that when you
change audio frequency, you may have to readjust the audio drive because of
ripples in the OP1 filter bandpass.
73, Chas
At 03:52 PM 11/13/2004, Dan Barker wrote:
Question about transmitter drive setup.
I'm about to go on the air with the K2 Power knob full clockwise, and the
soundcard drive (Digipan) set for about 1A draw on key down. Is that right?
Dan / WG4S / K2 #2456 with KPSK2, er, ah KSB2
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
