Greetings All, I'm building K2 SN 4245. When setting the AGC threshold I was not able to get 3.8 volts on pin 5 of U2 as described in the manual. The voltage varied from 2.60 to 3.78 when adjusting R1 to the extreme settings. Is this close enough or should I have more room for adjustment?
I have a faily good DMM, and it compares very closely to the K2 internal meter, and when checking values on 1% tolerance resisters. All other checks to date have been fine. Thanks and 73, Mike, W8ENG _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com