I'm aware of that setting, but the symptom is on 24 only, not on 28. Very odd.
Also, I didn't remember that it was for 12 also.
So, I set the Po28 to 15. Now both 24 and 28 show 15.2 as max requested. I set
it back to 10. Still both 24 and 28 show 15.2 as max requested. I'm guessing
the firmware got lost, at some point, and toggling Po28 fixed it. Now the
display is believable, and I've got a couple transformers to inspect for the
low power out on the higher bands.
Very interesting result.
Dan
k4zm sez:
<snip>
In your Secondard Menu of the firmware there is a setting called "Po28" it
comes defaulted to 10 watts and this controls the maximum output on 12 and 10
meters.
</snip>
________________________________________________________________
Sent via the WebMail system at visioncomm.net
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
