I just went through this with #4684.
I installed both feet on the bottom panel, stood the panel on edge,
installed the lower side of the tilt bail, and then "leaned on" the bail
till it was compressed enough to slide into place. I don't know how
anybody does it the way the manual says to do it without carving up the
bottom cover paint job while trying to hold the compressed bail and
start a screw.
--
R. Kevin Stover
AC0H
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com