Gary, The HiCut and LoCut are quite useful for SSB. To maintain intelligibilty while the width is narrowed, the low end must remain at about 300 Hz, while the High end can be reduced dramatically.
For use with CW, the shift and width controls are more useful - just reduce the width, and the center frequency stays the same (usually at your sidetone pitch). Slight changes in the shift control may be in order, but normally it will remain fixed. 73, Don W3FPR On 11/24/2010 9:32 PM, Gary wrote: > Thanks Nate. The audible effects are as I expected them to be when adjusting > low or high cut but the visual representations on both the K3 and the P3 > were not and had me a bit confused. I'll continue to experiment. > 73, > Gary > > -----Original Message----- > From: elecraft-boun...@mailman.qth.net > [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Nate Bargmann > Sent: Wednesday, November 24, 2010 1:32 PM > To: elecraft@mailman.qth.net > Subject: Re: [Elecraft] K3 LoCut/HiCut > > Gary, it may be easier to visualize each control manipulating a variable > high pass and low pass filter. The Lo Cut cuts off low frequencies, or > rather, sets the cutoff frequency of a high pass filter. The Hi Cut > does likewise, except it controls the cutoff frequency of a low pass > filter. They allow you to adjust either side of the passband > independently. You can acheive the same thing with the Width and Shift > controls it's just that the way the K3 is set up using Width works well > on CW as it adjusts both cutoff frequencies but maintains a constant > center frequency of the passband. On SSB using either the Lo or Hi Cut > controls can significantly reduce QRM from one side or the other. > > On my recently departed FT-920 only the Lo and Hi Cut controls were > available in the DSP. I like the K3's selection of either way of doing > it depending on the situation. Over this past SSB Sweepstakes I found > the Lo/Hi Cut indespensible for digging stations from between others. > > Experiment! > > 73, de Nate N0NB>> > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html