Ed, Check the schematic. You will find that one end of RB is connected to both RC and RD, and further connected to pins 2 and 3.
The troublesome one is usually RE which is close to one end of RC - those two points should not connect together. 73, Don W3FPR On 3/11/2011 8:57 PM, EMD wrote: > I think I created a solder bridge between the 1/8W resistor RB and the 3rd > pad under the resistor, on the PLL upgrade board. I have tried to wick up > the excess solder but I still cannot determine if this is okay or that the 2 > pads should be separate. > > 73, > Ed KE7HGA > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/PLL-upgrade-board-on-K2-7109-tp6163532p6163532.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html