I just use an unterminated SignaLink cable ( half an Ethernet jumper) and put on the right connectors that I purchased on-line.
I also used an iMic with a couple jumper cables of the right terminations but got funny noise so that is what led me to the SignaLink since I had one. Got the isolation I needed and works fine. 73 I did not connect the PTT inside the SignaLink, or rather I have a added in switch to connect or disconnect that line. I use the USB to KX3 control cable with flrig to control the KX3 using the K3 setting. 73, tom n4zpt On 5/22/2012 9:44 PM, Robert Galambos wrote: > so just came back from Dayton and found out a couple of things. > > 1) neither west mountain nor signallink external sound cards have cables > for the new KX3 > > 2) so given that i will try to set up the radio with using the internal > IMAC stereo line in for digital But the manual is light on the set up. I > assume that the output of the radio (read phone jack) goes into the in > line of the mac? but i figure there is another cable needed to transmit > the digital, i hope to create/write. so where does that cable go from > (from mac head phone to mic of the radio? > > I also have a USB cable to the ACC1 jack of the radio that should be > able to control it (CAT commands) > > > any help would be appreciated > > 73 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html