Plug the USB cable that is connected to the MicroHam Keyer into the PC. Be sure you have installed and run Router defining the necessary port numbers for all the features in the microKeyer you intend to use.
The big cable that you plugged into the back of the microKeyer with all the seperate leads you hooked up to the K3 - one of which is the serial interface (RS232). Now the communication between the PC and K3 is via the microKeyer. Works fine but for one task...FW updates. Be sure to note in the manual about not trying to do any firmware updates in this configuration. You MUST plug the K3 directly into the PC for these updates. Believe me, as the manual says, it does NOT work with the microKeyer in the middle. All information is pretty clear in the MicroHam manual. 73, Bob - W6OPO -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-P3-Microkeyer-tp7556989p7557038.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html